Logo

B1157 Engine Code Repair

Meaning of B1157 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B1157 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B1157 code is occuring now you should check B1157 repair processes.
Now don't ask yourself; What should you do with B1157 code ?
The solution is here :

B1157 Possible Solution:

B1157 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

B1157 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

1
Fuel And Air Metering

1
Ambient Air Temperature Sensor Circuit Low

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

7
Ignition Coil A Primary/Secondary Circuit Malfunction

Regarding the B1157 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B1157 OBD-II Diagnostic Body (B) Trouble Code Description

B1157 engine trouble code is about Ignition Coil A Primary/Secondary Circuit Malfunction.

Main reason For B1157 Code

The reason of B1157 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

Parts or components should not be replaced with reference to only a B1157 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.